SUPER MICRO Computer SUPERSERVER 6012P-6 User Manual download pdf (Page 93)

A-1

Appendix A: PhoenixBIOS POST Messages

Appendix A

PhoenixBIOS POST Messages

During the Power-On Self-Test (POST), the BIOS will check for problems. If a problem

is found, the BIOS will activate an alarm or display a message. The following is a list

of such BIOS messages.

Failure Fixed Disk

Fixed disk is not working or not configured properly. Check to see if fixed disk is

attached properly. Run Setup. Find out if the fixed-disk type is correctly identified.

Stuck key

Stuck key on keyboard.

Keyboard error

Keyboard not working.

Keyboard Controller Failed

Keyboard controller failed test. May require replacing keyboard controller.

Keyboard locked - Unlock key switch

Unlock the system to proceed.

Monitor type does not match CMOS - Run SETUP

Monitor type not correctly identified in Setup

Shadow Ram Failed at offset: nnnn

Shadow RAM failed at offset nnnn of the 64k block at which the error

was detected.

System RAM Failed at offset: nnnn

System RAM failed at offset nnnn of in the 64k block at which the error

was detected.

Extended RAM Failed at offset: nnnn Extended memory not

working or not configured properly at offset nnnn.

System battery is dead - Replace and run SETUP

The CMOS clock battery indicator shows the battery is dead. Replace the

battery and run Setup to reconfigure the system.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 109 110

No comments

SUPER MICRO Computer SUPERSERVER 6012P-6 User Manual Page 93