SUPER MICRO Computer 6016T-6RF+ User Manual download pdf (Page 56)

5-8

SUPERSERVER 6016T-6RFT+/6016T-6RF+ User's Manual

5-5 Installing Memory

Note: Check the Supermicro web site for recommended memory modules.

CAUTION

Exercise extreme care when installing or removing DIMM modules

to prevent any possible damage.

Installing DIMMs

1. Insert the desired number of DIMMs into the memory slots, starting with slot

P1-DIMM1A. For best performance, install memory modules of the same type

and same speed in the slots as indicated in the tables below.

2. Insert each DIMM vertically into its slot. Pay attention to the notch along the

bottom of the module to prevent inserting the DIMM module incorrectly (see

Figure 5-5).

3. Gently press down on the DIMM module until it snaps into place in the slot.

Repeat for all modules

Memory Support

The X8DTU-6TF+/X8DTU-6F+ supports up to 288 GB of registered ECC or 48 GB

of unbuffered ECC/non-ECC DDR3-1333/1066/800 SDRAM in 18 slots

Note: Memory speed support depends on the type of CPU used.

Figure 5-3. Installing DIMM into Slot

To Install: Insert module

vertically and press

down until it snaps into

place. Pay attention to

the alignment notch at

the bottom.

To Remove:

Use your thumbs to

gently push the release

tabs near both ends of

the module. This should

release it from the slot.

Top View of DDR3 Slot

Release Tab

Note: Notch should align

with the receptive key

point on the slot.

Notch

Front View

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 123 124

No comments

SUPER MICRO Computer 6016T-6RF+ User Manual Page 56